Arctic Cat DVX 300 Wartungshandbuch PDF herunterladen (Seite 13)

ATV0052B

When installing the spark plug, make sure to tighten it

securely. A new spark plug should be tightened 1/2 turn

once the washer contacts the cylinder head. A used spark

plug should be tightened 1/8-1/4 turn once the washer

contacts the cylinder head.

Muffler/Spark Arrester

The muffler has a spark arrester which must be periodi-

cally cleaned. At the intervals shown in the Periodic

Maintenance Chart, clean the spark arrester using the fol-

lowing procedure.

1. Remove the cap screw (1) securing the spark arrester

(2) to the muffler assembly; then carefully remove

the spark arrester.

KM139A

2. Using a soft wire brush, clean the carbon from the

screen (3) taking care not to tear or damage the screen.

KM140B

3. Install the spark arrester and secure with the cap

screw. Tighten securely.

Engine Oil - Filter

Replace the engine oil and clean the screen/filter at the

scheduled intervals. The engine should always be warm

when the oil is changed so the oil will drain easily and

completely.

1. Park the ATV on level ground.

2. Loosen the oil fill plug.

KM126A

3. Remove the screen/filter cap from the bottom of the

engine and drain the oil into a drain pan. Account for

a spring, O-ring, and screen/filter.

DSC02248

4. Clean the screen/filter in parts-cleaning solvent; then

inspect the O-ring and replace if damaged.

! WARNING

Wait until the muffler cools to avoid burns.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 117 118

Keine Kommentare

Arctic Cat DVX 300 Wartungshandbuch Seite 13