Arctic Cat DVX 300 Wartungshandbuch PDF herunterladen (Seite 20)

KM273A

3. Install the wheel. Tighten in a crisscross pattern to 40

ft-lb.

4. Remove the ATV from the support stand.

NOTE: Whenever installing new pads, the new pads

must be burnished (see Burnishing Brake Pads in

this section).

MEASURING/REPLACING REAR/

AUXILIARY BRAKE PADS (DVX)

Removing

NOTE: The brake caliper on the DVX contains two

sets of brake pads. The front pads are controlled by

the main brake lever and the rear pads are controlled

by the auxiliary brake pedal.

1. Remove the brake pad dust cover; then remove the

clip pin and pull the brake pad retaining pin out of

the caliper.

KM902B

KM244

2. Remove the brake spring plate; then remove the

brake pads.

KM905

Inspecting and Measuring

1. Inspect the pads for gouges, chips, or wear.

2. Inspect the disc for gouges, grooves, cracks, and

warpage.

3. Using a calipers, measure the thickness of each brake pad.

4. If the thickness of any brake pad is less than 1.0 mm

(0.039 in.), the brake pad must be replaced.

NOTE: The brake pads should be replaced as a set.

5. Using a calipers, measure the thickness of the disc. If

any portion of the disc is less than 3.00 mm (0.12

in.), the disc must be replaced (see Drive System -

Troubleshooting Brake System).

Installing

1. Install the brake pads in the caliper; then insert the

brake spring plate.

KM245

2. Install the brake pad retaining pin and secure with

the clip pin; then install the dust cover.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 117 118

Keine Kommentare

Arctic Cat DVX 300 Wartungshandbuch Seite 20