Arctic Cat DVX 300 Wartungshandbuch PDF herunterladen (Seite 54)

KM369

4. Place the fixed drive face into position on the crank-

shaft and engage the splines making sure the splines

extend beyond the pulley face hub.

KM263A

5. On the Utility, install the starter ratchet on the crank-

shaft making sure to engage the splines; then secure

with the flange nut and tighten to 68 ft-lb.

KM366

KM365

6. Install the centrifugal clutch housing and clutch collar;

then secure with the flange nut and tighten to 40 ft-lb.

KM253

KM368

7. Install the alignment pins and a new gasket on the

crankcase; then install the V-belt cover and secure

with the cap screws. Tighten securely.

8. On the Utility, install the recoil starter and secure

with the cap screws. Tighten securely.

Right-Side Components



NOTE: For efficiency, it is preferable to remove and

disassemble only those components which need to be

addressed and to service only those components. The

technician should use discretion and sound judgment.

NOTE: The engine/transmission does not have to

be removed from the frame for this procedure.

 AT THIS POINT

To service center crankcase components only, proceed

to Removing Right-Side Components.

AT THIS POINT

To service any one specific component, only limited dis-

assembly of components may be necessary. Note the

AT THIS POINT information in each sub-section.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 117 118

Keine Kommentare

Arctic Cat DVX 300 Wartungshandbuch Seite 54