Arctic Cat DVX 300 Wartungshandbuch Seite 76

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 118
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 75
73
Fuel/Lubrication/Cooling
Carburetor
0742-556
REMOVING
1. Remove the seat; then remove the gas tank (see Gas
Tank in this section).
2. Remove the cap screws securing the air filter hous-
ing to the frame; then loosen the clamp securing air
inlet boot to the carburetor and remove the air filter.
KM320A
3. Remove the choke assembly from the carburetor
leaving the choke cable attached to the choke
plunger.
.
KC0018
4. Remove the screw securing the throttle actuator
cover to the carburetor; then remove the cover.
PR154B
5. Remove the throttle cable from the actuator arm.
PR162C
6. Loosen the outer jam nut securing the throttle cable
to the carburetor body; then route the cable out of the
way.
! WARNING
Whenever any maintenance or inspection is performed
on the fuel system during which there may be fuel leak-
age, there should be no welding, smoking, open flames,
etc., in the area.
KEY
1. Screw
2. Top
3. Spring
4. Seat, Spring
5. Jet Needle
6. Vacuum Piston
7. Needle Jet
8. Needle Jet Holder
9. Main Jet
10. Starter Valve
11. Coil Spring
12. Cap
13. O-Ring
14. Cable
15. Tube
16. Pilot Screw
17. O-Ring
18. Float Arm Pin
19. Float
20. O-Ring
21. Slow Jet
22. Drain Screw
23. Float Valve
24. Float Valve Clip
25. Float Chamber
26. Screw
27. Clip
28. Drain Tube
29. Spring
30. Washer
31. Washer
32. Spring
33. Idle Adjust Screw
34. Top Cover
35. Screw
36. Starter Jet
Seitenansicht 75
1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 117 118

Kommentare zu diesen Handbüchern

Keine Kommentare