Arctic Cat DVX 300 Wartungshandbuch PDF herunterladen (Seite 46)

KM705

11. Install the cam chain tensioner cover bolt and tighten

to 24 in.-lb.

12. Check that the cam gear alignment marks are cor-

rectly oriented; then install and tighten the external

cylinder head to cylinder cap screws to 7 ft-lb.

13. Install the cylinder head cover with a new O-ring and

tighten securely.

KM703

14. Install the air pipe and vent hose using the existing

cap screws and clamp.

KM937A

KM938A

15. Install the air hose into the cylinder head.

KM941A

Left-Side Components

NOTE: For efficiency, it is preferable to remove and

disassemble only those components which need to

be addressed and to service only those components.

The technician should use discretion and sound

judgment.

NOTE: The engine/transmission does not have to

be removed from the frame for this procedure.

Removing Left-Side

Components

A. Recoil Starter (Utility)

1. Remove the five recoil starter cover cap screws.

Remove the recoil starter assembly noting the loca-

tion of the dowel pins. Note the condition of the

recoil cover gasket. Replace if damaged.

AT THIS POINT

To service any one specific component, only limited dis-

assembly of components may be necessary. Note the

AT THIS POINT information in each sub-section.

AT THIS POINT

To ser vice the recoil starter, see Servicing Left-Side

Components sub-section.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 117 118

Keine Kommentare

Arctic Cat DVX 300 Wartungshandbuch Seite 46