Arctic Cat DVX 300 Wartungshandbuch Seite 33
- Seite / 118
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
30
Removing Engine/
Transmission
Many service procedures can be performed without
removing the engine/transmission from the frame.
Closely observe the note introducing each sub-section for
this important information.
Secure the ATV on a support stand to elevate the wheels.
DVX
1. Remove the seat.
2. Remove the negative cable from the battery; then
remove the positive cable. Remove the battery hold-
down strap; then remove the battery.
3. Remove the reinstallable rivet from the bottom of the
electrical tray; then remove and lay the tray forward.
Leave the starter relay, fuse block, and CDI attached.
KM357
4. Remove the gas tank cover panel; then install the gas
tank cap and remove the gas tank vent hose.
5. Remove the body (see Steering/Frame/Controls).
6. Remove the air filter housing (see Fuel/Lubrication/
Cooling).
7. Remove the gas tank (see Fuel/Lubrication/Cooling).
8. Remove the muffler assembly (see Steering/Frame/
Controls).
9. Remove the carburetor (see Fuel/Lubrication/Cooling).
10. Remove the coil (see Electrical System).
11. Disconnect the stator connector, shift position con-
nector, and coolant temperature sensor.
KM348A
KM324A
12. Remove the starter positive wire; then remove the
engine ground wire.
KM319A
13. Drain the coolant, engine oil, and transmission gear lubri-
cant; then install the drain plugs and tighten to 21 ft-lb .
KM314A
AT THIS POINT
If the technician’s objective is to service/replace left-
side cover oil seals, the engine/transmission does not
have to be removed from the frame.
! WARNING
Make sure the ATV is solidly supported on the support
stand to avoid injury.
! WARNING
Battery acid is harmful if it contacts eyes, skin, or cloth-
ing. Care must be taken whenever handling a battery.
- SERVICE MANUAL 1
- FOREWORD 2
- TABLE OF CONTENTS 4
- General Information 5
- General Specifications 5
- Torque Specifications 6
- Torque Conversions 7
- (ft-lb/N-m) 7
- Break-In Procedure 7
- Gasoline - Oil - Lubricant 7
- Genuine Parts 8
- Preparation For Storage 8
- Preparation After 9
- SPECIAL TOOLS 10
- Lubrication Points 11
- Air Filter 11
- Valve/Tappet Clearance 11
- Testing Engine 12
- Compression 12
- Spark Plug 12
- Muffler/Spark Arrester 13
- Engine Oil - Filter 13
- Rear Drive Lubricant 14
- (Utility) 14
- Transmission Lubricant 14
- Drive Chain (DVX) 15
- ! WARNING 16
- Hydraulic Brake Systems 17
- INSPECTING HOSES 18
- CHECKING/REPLACING FRONT 18
- Auxiliary/Rear Hydraulic 19
- MEASURING/REPLACING REAR/ 20
- AUXILIARY BRAKE PADS (DVX) 20
- Removing 20
- Inspecting and Measuring 20
- Installing 20
- Burnishing Brake Pads 21
- Checking/Replacing 21
- Steering/Frame/Controls 23
- REMOVING (Utility) 24
- INSTALLING (DVX) 24
- Steering Post Cover/ 25
- Instrument Pod 25
- Steering Post/Tie Rods 26
- Measuring/Adjusting 28
- Toe-In/Toe-Out 28
- Front Brake Lever/Master 28
- Cylinder Assembly 28
- Auxiliary Brake Pedal/ 29
- Master Cylinder 29
- Assembly 29
- Throttle Control 30
- Engine/Transmission 32
- Removing Engine/ 33
- Transmission 33
- Top-Side Components 38
- Removing Top-Side 38
- Components 38
- AT THIS POINT 39
- Servicing Top-Side 40
- ATV1013A 41
- ATV-1011A 42
- ATV-1070 43
- ATV-1069 43
- ATV-1085B 43
- 726-306A 43
- Installing Top-Side 44
- C. Cylinder Head 45
- D. Valve Cover 45
- Left-Side Components 46
- Removing Left-Side 46
- Servicing Left-Side 47
- Cleaning and Inspecting 48
- Assembling/Installing 48
- V-BELT COVER 49
- DRIVE PULLEY 50
- DRIVEN PULLEY/CENTRIFUGAL 50
- CLUTCH ASSEMBLY 50
- Disassembling 50
- Inspecting 51
- Assembling 52
- Installing Left-Side 53
- Right-Side Components 54
- Removing Right-Side 55
- A. Transmission (Utility) 56
- Servicing Right-Side 60
- TRANSMISSION (Utility) 62
- SECONDARY GEARS 63
- Correcting Backlash 63
- Installing Right-Side 67
- Assembling Crankcase 69
- Joining Crankcase Halves 70
- Installing Engine/ 70
- Problem: Engine lacks power 75
- Condition Remedy 75
- Problem: Engine overheats 75
- Fuel/Lubrication/Cooling 76
- Carburetor 76
- Throttle Cable Free-Play 80
- Engine RPM (Idle) 80
- Gas Tank 80
- Gas Tank Valve 81
- Gas/Vent Hoses 81
- Oil Flow Chart 81
- Oil Pump 82
- Liquid Cooling System 82
- Radiator 82
- Hoses/Thermostat 83
- Water Pump 83
- Brakelight Switch 86
- (Auxiliary) 86
- (Handlebar Control) 86
- Coolant Temperature and 87
- Cooling Fan Switches 87
- Fan Motor 87
- Fuse Block 87
- Ignition Coil 88
- Indicator Lights (DVX) 89
- LCD Gauge Assembly 89
- Ignition Switch 90
- Handlebar Control 90
- Switches 90
- Magneto Coils 91
- Starter Motor 91
- Starter Relay 91
- CDI Unit 92
- Regulator/Rectifier 92
- Start-in-Gear Relay 92
- Headlights 93
- Taillight - Brakelight 93
- Ignition Timing 93
- Rear Drive Assembly 96
- Rear Drive Axle (DVX) 96
- Removing Bearings 98
- Installing Bearings 98
- Rear Drive Axle (Utility) 99
- CLEANING AND INSPECTING 101
- DISASSEMBLING 101
- ASSEMBLING 103
- Checking Tooth Contact 104
- AND BEARINGS 105
- Correcting Tooth Contact 105
- Checking Backlash 105
- REPLACING SWING ARM SEALS 105
- INSTALLING 106
- Troubleshooting 108
- Drive System 108
- Brake System 108
- Suspension 109
- Front and Rear 109
- Suspension Assembly 109
- Schematics 109
- Front Shock Absorbers 109
- Rear Shock Absorber 110
- Swing Arm 111
- ASSEMBLING AND INSTALLING 112
- Front A-Arms 114
- Wheels and Tires 116
Verwandte Produkte und Handbücher für Geländewagen Arctic Cat DVX 300
(6 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 1.202 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern